Since non-phase cycling is applied to the R1445 excitation pulse, four-phase cycling is applied to the detection pulse P1 for selecting the 0Q -> -1Q coherence order jump, and four-phase cycling is applied to the R1445 reconversion pulse for filtering DQ coherences.
;r14-4-5_2d (TopSpin 2.0) ;2D SQ-DQ correlation experiment with R14_4^5, use r14-4-5_1d for setup ;M. Carravetta, M. Eden, X. Zhao, A. Brinkmann and M.H. Levitt, ;Symmetry principles for the design of radiofrequency pulse seqeunces in ;the nuclear magnetic resonance of rotating solids, Chem. Phys. Lett 321 (2000) 205-215 ;by JOS 02/28/03 ;Avance II+ version ;parameters: ;d1 : recycle delay ;d0 : incremented delay (2D) [1 usec] ;d20 : delay between saturation pulses ;p1 : detection pulse with pl1 power ;pl1 : f1 power level ;pl11 : for R14_4^5 recoupling sequence B1=(N/2n)*cnst31=1.75*cnst31 in Hz ;cnst31 : spinning speed ;l0 : number of basic R14_4^5 cycles for DQ excitation ;l3 : number of rotor period for DQ evolution ;l20 : # of pulses in saturation pulse train ;in0 : l3*rotorperiod=l3*(1/cnst31), t1 increment ;ns : n*16 ;FnMode : undefined ;mc2 : STATES-TPPI ;nd0 : 1 ;zgoptns :-Dpresat or blank ;$COMMENT=SQ-DQ experiment with R14_4^5 ;$CLASS=Solids ;$DIM=2D ;$TYPE=direct excitation ;$SUBTYPE=homonuclear correlation ;$OWNER=Bruker define loopcounter count ;for STATES-TPPI procedure "count=td1/2" ;and STATES cos/sin procedure define pulse pul180 "pul180=(2.0s/cnst31)/7" ;180° pulse "d31=1s/cnst31" "d0=1u" "in0=l3*d31" "inf1=l3*d31" ;cnst11 : to adjust t=0 for acquisition, if digmod = baseopt "acqt0=1u*cnst11" #include <rot_prot.incl> ze ;acquire into a cleared memory 1 d31 #ifdef presat ;set with -Dpresat pres, d20 ;delay between saturation pulses (p1 pl1 ph1):f1 ;saturation loop if required lo to pres times l20 #endif /* presat */ 2 d1 ;recycle delay 1m rpp11 ;reset the phase ph11 pointer to the first element ;in the DQ excitation pulse 1m rpp13 ;reset the phase ph13 pointer to the first element ;in the DQ reconversion pulse 10u reset:f1 1u pl11:f1 ;switch to R14_4^5 RF condition ;R14_4^5 DQ excitation 3 (pul180 ph11 ipp11):f1 ;increment phase ph11 pointer (pul180 ph11 ipp11):f1 ;increment phase ph11 pointer lo to 3 times l0 d0 ;DQ evolution ;R14_4^5 DQ reconversion 4 (pul180 ph13 ipp13):f1 ;increment phase ph13 pointer (pul180 ph13 ipp13):f1 ;increment phase ph13 pointer lo to 4 times l0 (p1 pl1 ph5):f1 ;detection pulse gosc ph31 ;gosc does not loop to 1 ;DQ filtering (four phase cycling): 1m ip13*16384 ;increments all phases of ph13 by 90° lo to 1 times ns ;next scan 100m wr #0 if #0 zd ;save data 1m ip11*8192 ;increments all phases of ph11 by 45°, ;90° phase for DQ coherence lo to 1 times 2 ;t1 quadrature detection 1m id0 ;increment in l3*rotorperiod ;1m rp11 ;reset all phases of ph11 and ph13 ;to their original values, i.e. to the values they ;1m rp13 ;had before the first ip11 and ip13 ;in case of STATES remove semicolon at beginning of the 2 lines lo to 1 times count ;count=td1/2 HaltAcqu, 1m exit ph1=0 ;for saturation pulse ph11=(65536) 11704 53832 ; 64.29° 295.71° or 64.29° -64.29° ph13=(65536) 28088 4680 ;154.29° 25.71° or ph11 + 90° ph5= 0 0 0 0 2 2 2 2 1 1 1 1 3 3 3 3 ph31=0 2 0 2 2 0 2 0 1 3 1 3 3 1 3 1
31P R14_4^5 DQ/SQ spectrum of VPI-5 zeolite with big DQ F1 spectral width, acquired with a 2.5-mm diameter rotor spinning at 30.1 kHz, D1 = 10 sec recycle delay, and recorded with Bruker Avance III, 700 MHz SB US magnet, BLAX500W.
Pulseprogram parameters for r14-4-52d.ppm:
General | |
PULPROG | r14-4-52d.ppm |
TD | 1024 |
NS | 48 |
DS | 0 |
SWH [Hz] | 12500.00 |
AQ [s] | 0.0410500 |
RG | 256 |
DW [µs] | 40.000 |
DE [µs] | 5.00 |
CNST11 | 0.0000000 |
CNST31 | 30100.0000000 |
D0 [s] | 0.00000100 |
D1 [s] | 10.00000000 |
D20 [s] | 0.00800000 |
d31 [s] | 0.00003322 |
in0 [s] | 0.00003322 |
inf1 [µs] | 33.22 |
L0 | 50 |
L20 | 20 |
ZGOPTNS | -Dpresat |
count | 60 |
Channel f1 | |
CNST1 | 1.0000000 |
NUC1 | 31P |
P1 [µs] | 5.75 |
PL1 [dB] | 8.00 |
PL11 [dB] | 7.00 |
pul180 [µs] | 9.49 |
SFO1 [MHz] | 283.3494808 |
Acquisition parameters:
F2 | F1 | |
Experiment | ||
PULPROG | r14-4-52d.ppm | |
AQ_mod | DQD | |
FnMODE | undefined | |
TD | 1024 | 120 |
NS | 48 | |
DS | 0 | |
TD0 | 1 | |
Width | ||
SW [ppm] | 44.1151 | 43.0092 |
SWH [Hz] | 12500.000 | 30102.348 |
IN_F [µs] | 33.22 | |
AQ [s] | 0.0410500 | 0.0019932 |
Nucleus1 | ||
NUC1 | 31P | |
O1 [Hz] | -7617.18 | -7617.18 |
O1P [ppm] | -26.882 | -26.882 |
SFO1 [MHz] | 283.3494808 | 283.3494808 |
BF1 [MHz] | 283.3570980 | 283.3570980 |