Since non-phase cycling is applied to the R1225 excitation pulse, four-phase cycling is applied to the detection pulse P1 for selecting the 0Q -> -1Q coherence order jump, and four-phase cycling is applied to the R1225 reconversion pulse for filtering DQ coherences.
Per Eugen Kristiansen, Dan J. Mitchell, and Jeremy N. S. Evans
Double-quantum dipolar recoupling at high magic-angle spinning rates,
J. Magn. Reson. 157, 253-266 (2002).
Abstract
Marina Carravetta and coworkers
Estimation of carbon-carbon bond lengths and medium-range
internuclear distances by solid-state nuclear magnetic resonance,
J. Am. Chem. Soc. 123, 10628-10638 (2001).
Abstract
;r12-2-5_2dbsw (TopSpin 2.0) ;2D SQ-DQ correlation experiment with R12_2^5, use r12-2-5_1d for setup ;M. Carravetta, M. Eden, X. Zhao, A. Brinkmann and M.H. Levitt, ;Symmetry principles for the design of radiofrequency pulse seqeunces in ;the nuclear magnetic resonance of rotating solids, Chem. Phys. Lett 321 (2000) 205-215 ;by JOS 02/28/03 ;Avance II+ version ;parameters: ;d1 : recycle delay ;d0 : incremented delay (2D) [1 usec] ;d20 : delay between saturation pulses ;p1 : detection pulse with pl1 power ;p9 : used as t1 increment (= inf1) for d0 ;pl1 : f1 power level ;pl11 : for R12_2^5 recoupling sequence B1=(N/2n)*cnst31=3*cnst31 in Hz ;cnst31 : spinning speed ;l0 : number of basic R12_2^5 cycles for DQ excitation ;l20 : # of pulses in saturation pulse train ;ns : n*16 ;FnMode : undefined ;mc2 : STATES-TPPI ;nd0 : 1 ;WDW : F1 QSINE 3, F2 QSINE 2 or EM ;use "xau xfshear rotate" to shift spectrum suitably along f1 ;zgoptns :-Dpresat or blank ;$COMMENT=SQ-DQ experiment with R12_2^5 ;$CLASS=Solids ;$DIM=2D ;$TYPE=direct excitation ;$SUBTYPE=homonuclear correlation ;$OWNER=Bruker define loopcounter count ;for STATES-TPPI procedure "count=td1/2" ;and STATES cos/sin procedure define pulse pul180 "pul180=(1.0s/cnst31)/6" ;180° pulse "d31=1s/cnst31" ;cnst11 : to adjust t=0 for acquisition, if digmod = baseopt "acqt0=1u*cnst11" #include <rot_prot.incl> ;protect for too slow rotation ze ;acquire into a cleared memory "d0=0.1u" ;make sure a short d0 is used initially 1 d31 #ifdef presat ;set with -Dpresat pres, d20 ;delay between saturation pulses (p1 pl1 ph1):f1 ;saturation loop if required lo to pres times l20 #endif /* presat */ 2 d1 ;recycle delay "cnst1=-180*cnst31*d0" ;phase correction for R12_2^5 reconversion pulse, ;due to t1 DQ evolution period, ;defined by the phase-time relationships 1m rpp11 ;reset the phase ph11 pointer to the first element ;in the DQ excitation pulse 1m rpp13 ;reset the phase ph13 pointer to the first element ;in the DQ reconversion pulse 10u reset:f1 1u pl11:f1 ;switch to R12_2^5 RF condition ;R12_2^5 DQ excitation 3 (pul180 ph11 ipp11):f1 ;increment phase ph11 pointer (pul180 ph11 ipp11):f1 ;increment phase ph11 pointer lo to 3 times l0 d0 ;DQ evolution ;R12_2^5 DQ reconversion 4 (pul180 ph13+cnst1 ipp13):f1 ;increase ph13 by cnst1 due to evolution period ;increment phase ph13 pointer (pul180 ph13+cnst1 ipp13):f1 ;increase ph13 by cnst1 due to evolution period ;increment phase ph13 pointer lo to 4 times l0 (p1 pl1 ph5):f1 ;detection pulse gosc ph31 ;gosc does not loop to 1 ;DQ filtering (four phase cycling): 1m ip13*16384 ;increments all phases of ph13 by 90° lo to 1 times ns ;next scan 100m wr #0 if #0 zd ;save data 1m ip11*8192 ;increments all phases of ph11 by 45°, ;90° phase for DQ coherence lo to 1 times 2 ;t1 quadrature detection "d0=d0+p9" ;set p9=increment for F1 (to make it usec!) ;1m rp11 ;reset all phases of ph11 and ph13 ;to their original values, i.e. to the values they ;1m rp13 ;had before the first ip11 and ip13 ;in case of STATES remove semicolon at beginning of the 2 lines lo to 1 times count ;count=td1/2 HaltAcqu, 1m exit ph1=0 ;for saturation pulse ph11=(65536) 13653 51883 ; 75° 285° or 75° -75° ph13=(65536) 30037 2731 ;165° 15° or ph11 + 90° ph5= 0 0 0 0 2 2 2 2 1 1 1 1 3 3 3 3 ph31=0 2 0 2 2 0 2 0 1 3 1 3 3 1 3 1
31P MAS spectra of VPI-5 zeolite versus the excitation pulse p1 duration (pl1 = 8 dB) in zgsat.gul pulse program, acquired with a 2.5-mm diameter rotor spinning at 30 kHz, D1 = 10 sec recycle delay, and recorded with Bruker Avance III, 700 MHz SB US magnet.
Pulseprogram parameters for zgsat.gul:
General | |
PULPROG | zgsat.gul |
TD | 2048 |
NS | 4 |
DS | 0 |
SWH [Hz] | 50000.00 |
AQ [s] | 0.0205300 |
RG | 256 |
DW [µs] | 10.000 |
DE [µs] | 5.00 |
D1 [s] | 10.00000000 |
D20 [s] | 0.00800000 |
L20 | 20 |
TD0 | 1 |
Channel f1 | |
NUC1 | 31P |
P1 [µs] | 4.00 |
P20 [µs] | 5.50 |
PL1 [dB] | 8.00 |
PL1W [W] | 36.86472321 |
SFO1 [MHz] | 283.4086637 |
31P MAS spectra of VPI-5 zeolite versus the excitation power pl11 (l0 = 160) in r12-2-5_1d.ppm, acquired with a 2.5-mm diameter rotor spinning at 20 kHz, D1 = 10 sec recycle delay, and recorded with Bruker Avance III, 700 MHz SB US magnet.
Pulseprogram parameters for r12-2-5_1d.ppm:
General | |
PULPROG | r12-2-5_1d.ppm |
TD | 2048 |
NS | 16 |
DS | 0 |
SWH [Hz] | 50000.00 |
AQ [s] | 0.0205300 |
RG | 256 |
DW [µs] | 10.000 |
DE [µs] | 5.00 |
CNST11 | 0.0000000 |
CNST31 | 20000.0000000 |
D1 [s] | 10.00000000 |
D20 [s] | 0.00800000 |
d31 [s] | 0.00005000 |
L0 | 160 |
L20 | 20 |
ZGOPTNS | -Dpresat |
Channel f1 | |
NUC1 | 31P |
P1 [µs] | 4.00 |
PL1 [dB] | 8.00 |
PL1W [W] | 36.86472321 |
PL11 [dB] | 9.50 |
PL11W [W] | 26.09822655 |
pul180 [µs] | 8.33 |
SFO1 [MHz] | 283.4086637 |
31P MAS spectra of VPI-5 zeolite versus the number l0 of basic unit (pl11 = 9.5 dB) in r12-2-5_1d.ppm, acquired with a 2.5-mm diameter rotor spinning at 20 kHz, D1 = 10 sec recycle delay, and recorded with Bruker Avance III, 700 MHz SB US magnet.
Pulseprogram parameters for r12-2-5_1d.ppm:
General | |
PULPROG | r12-2-5_1d.ppm |
TD | 2048 |
NS | 16 |
DS | 0 |
SWH [Hz] | 50000.00 |
AQ [s] | 0.0205300 |
RG | 256 |
DW [µs] | 10.000 |
DE [µs] | 5.00 |
CNST11 | 0.0000000 |
CNST31 | 20000.0000000 |
D1 [s] | 10.00000000 |
D20 [s] | 0.00800000 |
d31 [s] | 0.00005000 |
L0 | 150 |
L20 | 20 |
ZGOPTNS | -Dpresat |
Channel f1 | |
NUC1 | 31P |
P1 [µs] | 4.00 |
PL1 [dB] | 8.00 |
PL1W [W] | 36.86472321 |
PL11 [dB] | 9.50 |
PL11W [W] | 26.09822655 |
pul180 [µs] | 8.33 |
SFO1 [MHz] | 283.4086637 |
31P R12_2^5 DQ/SQ spectrum of VPI-5 zeolite with big DQ F1 spectral width, acquired with a 2.5-mm diameter rotor spinning at 20 kHz, D1 = 10 sec recycle delay, P9 = 4*pul180, and recorded with Bruker Avance III, 700 MHz SB US magnet.
Pulseprogram parameters for r12-2-52dbsw.ppm:
General | |
PULPROG | r12-2-52dbsw.ppm |
TD | 2048 |
NS | 32 |
DS | 0 |
SWH [Hz] | 50000.00 |
AQ [s] | 0.0205300 |
RG | 256 |
DW [µs] | 10.000 |
DE [µs] | 5.00 |
CNST11 | 0.0000000 |
CNST31 | 20000.0000000 |
D0 [s] | 0.00000300 |
D1 [s] | 10.00000000 |
D20 [s] | 0.00800000 |
d31 [s] | 0.00005000 |
L0 | 150 |
L20 | 20 |
P9 [µs] | 33.32 |
ZGOPTNS | -Dpresat |
count | 128 |
Channel f1 | |
CNST1 | 1.0000000 |
NUC1 | 31P |
P1 [µs] | 4.00 |
PL1 [dB] | 8.00 |
PL1W [W] | 36.86472321 |
PL11 [dB] | 9.50 |
PL11W [W] | 26.09822655 |
pul180 [µs] | 8.33 |
SFO1 [MHz] | 283.4086637 |
Acquisition parameters:
F2 | F1 | |
Experiment | ||
PULPROG | r12-2-52dbsw.ppm | |
AQ_mod | DQD | |
FnMODE | undefined | |
TD | 2048 | 256 |
NS | 32 | |
DS | 0 | |
TD0 | 1 | |
Width | ||
SW [ppm] | 176.4237 | 42.8710 |
SWH [Hz] | 50000.000 | 30012.006 |
IN_F [µs] | 33.32 | |
AQ [s] | 0.0205300 | 0.0042650 |
Nucleus1 | ||
NUC1 | 31P | |
O1 [Hz] | -9155.27 | |
O1P [ppm] | -32.303 | |
SFO1 [MHz] | 283.4086637 | |
BF1 [MHz] | 283.4178190 |